![]() ![]() If that's confusing I'll try to explain with more complicated interstate highway anecdote. You could still have unganged single channel or dual channel, and ganged single channel or dual channel. Unganged is said to be more efficient but no one really ever tested this thoroughly to see if any applications would be better served in ganged instead. Ganged let's traffic use all of the lanes in one direction at a time. Unganged is like a normal divided highway with two directions. Versions apply the same timings automatically for both DCTs in an Unganged mode. Higher Memory performance tuning and performs well in single-threaded benchmarks.ĭepending on the motherboard and BIOS, it may be required manually setting the timing parameters for eachĭCT (in Unganged mode) when performance tuning the memory or fine tuning the timings. The recommended setting in most cases is the Unganged memory mode. Unganged mode enables two 64bit wide DRAM Controllers (DCT0 and DCT1). ![]() Ganged mode means that there is a single 128bit wide dual-channel DRAM Controller (DCT)Įnabled. Ganged vs Unganged: that actually doesn't have to do with single or dual channel. I would like to share the screenshots but the system is not allowing me to.Great article, Tradesman! I give it Two thumbs up and two big toes up too! ![]() It turned out that it can be a bigger issue, maybe related to the motherboard because i am not able to see Mermory, Mainboard and SPD infos on the CPU-Z they are almost totally blank. RemoveDirectory C:\Windows\temp\cpuz149\ succeeded DeleteFile C:\Windows\temp\cpuz149\cpuz149_圆4.sys succeeded szDestName = C:\Windows\temp\cpuz149\cpuz149_圆4.sys Extract C:\Windows\temp\cpuz149\cpuz149_圆4.sys Two of the program's tabs are DRAM-related: the SPD tab and the Memory tab. RemoveDirectory C:\Windows\temp\cpuz149\ failed (error = 2) The answer to this question depends on what you are looking at in CPU-Z. DeleteFile C:\Windows\temp\cpuz149\cpuz149_圆4.sys failed (error = 3) GetModuleFileName = C:\Program Files\CPUID\CPU-Z\cpuz.exe GetCurrentDirectory = C:\Program Files\CPUID\CPU-Z ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |